To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
Axle nut
Drive chain slack adjusting bolt
Locknut
Brake caliper
TIP
If the drive chain is difficult to remove,
remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
The drive chain cannot be disassembled.
To install the rear wheel
TIP
Retainer
Slot
Tightening torque: Axle nut: 85 Nm (8.5 m.kgf, 61 ft.lbf) |
Checking the front brake lever free play
Checking the front brake lever free play
Brake lever free play
The brake lever free play should measure
2.0-5.0 mm (0.08-0.20 in) as
shown. Periodically check the brake lever
free play and, if necessary, have a
Yamaha dealer check the brake system.
WARNING
An incorrect brake le ...
Checking the brake fluid level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Check:
Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
A. Front brake
B. Rear brake
WA ...
Handlebar switches
Left
Left
1. Pass switch "PASS"
2. Dimmer switch "/"
3. Turn signal switch "/"
4. Horn switch""
Right
Right
Engine stop switch "/"
Start switch""
Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch "/"
Set this switch to""
for the high
beam an ...