Yamaha YZF-R125 Service Manual: Periodic checks and adjustments
- Periodic maintenance
- Engine
- Adjusting the valve clearance
- Adjusting the exhaust gas volume
- Adjusting the engine idling speed
- Adjusting the throttle cable free play
- Checking the spark plug
- Checking the ignition timing
- Measuring the compression pressure
- Checking the engine oil level
- Changing the engine oil
- Adjusting the clutch cable free play
- Cleaning the air filter element
- Checking the throttle body joint and air filter case joint
- Checking the fuel line
- Checking the cylinder head breather hose
- Checking the exhaust system
- Checking the coolant level
- Checking the cooling system
- Changing the coolant
- Chassis
- Adjusting the rear disc brake
- Checking the brake fluid level
- Checking the front brake pads
- Checking the rear brake pads
- Checking the front brake hose
- Checking the rear brake hose
- Bleeding the hydraulic brake system
- Adjusting the drive chain slack
- Lubricating the drive chain
- Checking and adjusting the steering head
- Checking the front fork
- Checking the tires
- Checking the wheels
- Checking and lubricating the cables
- Electrical system
Cable routing
Front brake light switch lead
Right handlebar switch lead
Throttle cable
Main switch
Clutch cable
Clutch switch lead
Left handlebar switch lead
Sub-wire harness
Horn
Speed sen ...
Other materials:
Replacing a turn signal light bulb
Remove the turn signal light lens
by removing the screw.
Screw
Remove the burnt-out bulb by
pushing it in and turning it counterclockwise.
Insert a new bulb into the socket,
push it in, and then turn it clockwise
until it stops.
Install the lens by installing ...
Chassis tightening torques
NOTE:
First, tighten the lower ring nut to approximately 48 Nm (4.8 m.kg,
35 ft.lb) with a torque wrench, then
loosen the lower ring nut completely.
Retighten the lower ring nut to 13 Nm (1.3 m.kg, 9.4 ft.lb) with a
torque wrench.
...
Checking and replacing the rear wheel sprocket
1. Check:
Rear wheel sprocket
More than 1/4 tooth "a" wear
Replace the
rear wheel sprocket.
Bent teeth Replace the rear
wheel sprocket.
b. Correct
1. Drive chain roller
2. Rear wheel sprocket
2. Replace:
Rear wheel sprocket
a. Remove the self-locking nuts and the ...