1. Multi-function display
2. "RESET/SELECT" button
NOTE:
Odometer and tripmeter modes
A brief push (less than one second) on the "RESET/ SELECT" button switches the display between the odometer mode "ODO" and the tripmeter modes "TRIP 1" and "TRIP 2" in the following order:
ODO →TRIP 1 →TRIP 2 → ODO
When approximately 1.6 L (0.42 US gal) (0.35 Imp.gal) of fuel remains in the fuel tank, the odometer display will automatically change to the fuel reserve tripmeter mode "F-TRIP" and start counting the distance traveled from that point, and the last segment of the fuel meter will start flashing. In that case, pushing the "RESET/ SELECT" button switches the display between the various tripmeter and odometer modes in the following order:
F-TRIP → TRIP 1 → TRIP 2 → ODO → F-TRIP
To reset a tripmeter, select it by pushing the "RESET/SELECT" button briefly (less than one second), and then push the button for at least three seconds while the selected tripmeter is flashing. If you do not reset the fuel reserve tripmeter manually, it will reset itself automatically and the display will return to the prior mode after refueling and traveling 5 km (3 mi).
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of fuel in the fuel tank. The display segments of the fuel meter disappear towards "E" (Empty) as the fuel level decreases. When the last fuel meter segment starts flashing, refuel as soon as possible.
Checking the ignition timing
NOTE:
Prior to checking the ignition timing, check the
wiring connections of the entire ignition system.
Make sure all connections are tight and free of
corrosion.
1. Remove:
Rider seat
Left lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Timing mark acces ...
VInstalling the handlebars
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Install:
Front brake master cylinder "1"
Front brake master cylinder holder "2"
Front brake light switch
NOTE:
Install the brake master cyl ...
Checking and lubricating the cables
The following procedure applies to all of the inner
and outer cables.
WARNINGDamaged outer cable may cause the cable to
corrode and interfere with its movement. Replace
damaged outer cable and inner cables
as soon as possible.
1. Check:
Outer cable
Damage Replace.
2 ...