NOTE:
Insufficient compression pressure will result in a loss of performance.
1. Measure:
Valve clearance Out of specification →Adjust.
Refer to "ADJUSTING THE VALVE CLEARANCE" on page 3-3.
2. Start the engine, warm it up for several minutes, and then turn it off.
3. Remove:
4. Remove:
5. Disconnect:
6. Remove:
CAUTION: Before removing the spark plug, use compressed air to blow away any dirt accumulated in the spark plug well to prevent it from falling into the cylinder. |
7. Install:
8. Measure:
a. Set the main switch to "ON".
b. With the throttle wide open, crank the engine until the reading on the compression gauge stabilizes.
c. If the compression pressure is above the maximum specification, check the cylinder head, valve surfaces and piston crown for carbon deposits.
Carbon deposits Eliminate.
d. If the compression pressure is below the minimum specification, pour a teaspoonful of engine oil into the spark plug bore and measure again.
Refer to the following table.
9. Remove:
10.Install:
11.Connect:
12.Install:
13.Install:
Checking the cylinder head breather hose
1. Remove:
Left side panel
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Cylinder head breather hose "1"
Cracks/damage → Replace.
Loose connection → Connect properly.
CAUTION:Make sure the cylinder head
breather hose is
routed correctly.
...
Adjusting the clutch lever free play
Adjusting the clutch lever free play
Clutch lever free play adjusting bolt
Clutch lever free play
The clutch lever free play should measure
10.0-15.0 mm (0.39-0.59 in) as
shown. Periodically check the clutch lever
free play and, if necessary, adjust it
as follows.
Slide the ...
Tires
To maximize the performance, durability,
and safe operation of your motorcycle,
note the following points regarding
the specified tires.
Tire air pressure
The tire air pressure should be checked
and, if necessary, adjusted before each
ride.
WARNING
Operation of this vehicle with impro ...