The drive chain consists of many interacting parts. If the drive chain is not maintained properly, it will wear out quickly. Therefore, the drive chain should be serviced, especially when the vehicle is used in dusty areas.
This vehicle has a drive chain with small rubber O-rings between each side plate. Steam cleaning, high-pressure washing, certain solvents, and the use of a coarse brush can damage these O-rings. Therefore, use only kerosene to clean the drive chain. Wipe the drive chain dry and thoroughly lubricate it with engine oil or chain lubricant that is suitable for O-ring chains.
Do not use any other lubricants on the drive chain since they may contain solvents that could damage the O-rings.
Safe Riding
Perform the pre-operation checks each
time you use the vehicle to make sure it
is in safe operating condition. Failure to
inspect or maintain the vehicle properly
increases the possibility of an accident
or equipment damage. See page 4-1
for a list of pre-operation checks.
This motor ...
Checking the fuses
The following procedure applies to all of the fuses.
CAUTION:To avoid a short circuit, always turn the
main
switch to "OFF" when checking or replacing
a fuse.
1. Remove:
Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Fuse
a. Connect the pocket te ...
Checking the clutch springs
The following procedure applies to all of the
clutch springs.
1. Check:
Clutch spring
Damage Replace the clutch
springs as a
set.
2. Measure:
Clutch spring free length "a"
Out of specification Replace
the clutch
springs as a set.
...