Yamaha YZF-R125 Service Manual: Introduction

Yamaha YZF-R125 Service Manual / Chassis / Rear brake / Introduction

WARNING

Disc brake components rarely require disassembly.

Therefore, always follow these preventive measures:

Never disassemble brake components unless absolutely necessary.
If any connection on the hydraulic brake system is disconnected, the entire brake system must be disassembled, drained, cleaned, properly filled, and bled after reassembly.
Never use solvents on internal brake components.
Use only clean or new brake fluid for cleaning brake components.
Brake fluid may damage painted surfaces and plastic parts. Therefore, always clean up any spilt brake fluid immediately.
Avoid brake fluid coming into contact with the eyes as it can cause serious injury.
FIRST AID FOR BRAKE FLUID ENTERING THE EYES:
Flush with water for 15 minutes and get immediate medical attention.

Checking the rear brake disc

1. Remove: Rear wheel Refer to "REAR WHEEL" on page 4-12. 2. Check: Brake disc Damage/galling → Replace. 3. Measure: Brake disc deflection Out of specification → Correc ...

Other materials:

Owner's tool kit
Owner's tool kit Owner's tool kit Engine oil drain attachment The owner's tool kit is located under the rider seat. The service information included in this manual and the tools provided in the owner's tool kit are intended to assist you in the performance of preventive maint ...

Installing the thermostat
1. Install: Thermostat NOTE: Install the thermostat with its breather hole "a" facing up. 2. Install: Copper washer Coolant temperature sensor CAUTION:Use extreme care when handling the coolant temperature sensor. Replace any part that was dropped or subjected to ...

Checking the valves and valve guides
The following procedure applies to all of the valves and valve guides. 1. Measure: Valve-stem-to-valve-guide clearance Out of specification Replace the valve guide. Valve-stem-to-valve-guide clearance = Valve guide inside diameter "a" - Valve stem diameter "b" 2. Replace: ...