1. Check:
a. Connect the pocket tester ( ×
1k) to the
throttle body sensor assembly coupler as
shown.
b. Measure the intake air temperature sensor resistance.
Checking the speed sensor
1. Check:
Speed sensor output voltage
Out of specification → Replace.
a. Connect the pocket tester (DC 20 V) to the
speed sensor coupler (wire harness end) as
shown.
Positive tester probe
gray "1"
Negative tester probe
gray/black "2"
b. Set the main switch to "ON".
c. ...
Troubleshooting
The starter motor fails to turn.
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Left lower side cowling
4. Left upper side cowling
...
Checking the diode
1. Check:
Diode
Out of specification Replace.
NOTE:
The pocket tester or the analog pocket tester
readings are shown in the following table.
a. Disconnect the diode from the wire harness.
b. Connect the pocket tester ( × 1)
to the diode
terminals as shown.
c. Check the diod ...