1. Check:
a. Connect the pocket tester (DC 20 V) to the throttle body sensor assembly coupler as shown.
b. Set the main switch to "ON".
c. Measure the intake air pressure sensor output voltage.
Checking the clutch springs
The following procedure applies to all of the
clutch springs.
1. Check:
Clutch spring
Damage Replace the clutch
springs as a
set.
2. Measure:
Clutch spring free length "a"
Out of specification Replace
the clutch
springs as a set.
...
Checking the starter motor
1. Check:
Commutator
Dirt Clean with 600 grit
sandpaper.
2. Measure:
Commutator diameter "a"
Out of specification Replace
the starter
motor.
3. Measure:
Mica undercut "a"
Out of specification Scrape
the mica to the
proper measurement with a hacksaw blade
...
Rider seat
To remove the rider seat
Insert the key into the seat lock,
and then turn it clockwise.
Seat lock
Open.
Pull the rider seat off.
To install the rider seat
1. Insert the projection on the front of
the rider seat into the seat holder
as shown.
Projection
...