1. Install:
NOTE:
Align the projections "a" on the throttle body joint with the slot "b" in each throttle body joint clamp.
2. Install:
NOTE:
Align the projection "a" on the throttle body joint with the slot "b" in the intake manifold.
3. Install:
NOTE:
Align the projection "a" on the throttle body with the slot "b" in the throttle body joint.
4. Adjust:
Throttle cable free play Refer to "ADJUSTING THE THROTTLE CABLE FREE PLAY" on page 3-6.
5. Connect:
CAUTION: When installing the fuel hose, make sure that it is securely connected, and that the fuel hose connector cover on the fuel hose is in the correct position, otherwise the fuel hose will not be properly installed. |
NOTE:
Checking the clutch springs
The following procedure applies to all of the
clutch springs.
1. Check:
Clutch spring
Damage Replace the clutch
springs as a
set.
2. Measure:
Clutch spring free length "a"
Out of specification Replace
the clutch
springs as a set.
...
Checking the rear brake hose
1. Check:
Brake hoses "1"
Cracks/damage/wear
Replace.
2. Check:
Brake hose holder "2"
Loose connection Tighten the
holder bolt.
Loose or open holder Fasten
properly.
3. Hold the vehicle upright and apply the rear
brake several times.
4. Check:
Brake ho ...
Checking the front brake master cylinder
1. Check:
Brake master cylinder
Damage/scratches/wear Replace.
Brake fluid delivery passages
(brake master cylinder body)
Obstruction Blow out with
compressed air.
2. Check:
Brake master cylinder reservoir
Cracks/damage Replace the brake
master
cylinder.
Brake maste ...