1. Install:
NOTE:
Install the thermostat with its breather hole "a" facing up.
2. Install:
CAUTION: Use extreme care when handling the coolant temperature sensor. Replace any part that was dropped or subjected to a strong impact. |
3. Fill:
4. Check:
5. Measure:
Refer to "CHECKING THE RADIATOR" on page 6-3.
Checking the horn
1. Check:
Horn resistance
Out of specification Replace.
a. Disconnect the horn connectors from the
horn terminals.
b. Connect the pocket tester ( × 1) to the horn
terminals.
Positive tester probe
horn terminal "1"
Negative tester probe
horn terminal "2"
c. Measure t ...
Identification
Vehicle identification number
The vehicle identification number "1" is stamped
into the right side of the steering head pipe.
Model label
The model label "1" is affixed to the frame. This
information will be needed to order spare parts.
...
Checking the thermostat
1. Check:
Thermostat
Does not open at 80.5-83.5 C (176.9-182.3
F) Replace.
a. Suspend the thermostat "1" in a container "2"
filled with water.
b. Slowly heat the water "3".
c. Place a thermometer "4" in the water.
d. While stirring the water, observe the thermostat
and th ...