1. Lubricate:
2. Install:
2. Swingarm
A. Left side
B. Right side
3. Install:
a. Install, and then fully turn in the swingarm adjusting collar so that it contacts the frame.
b. Install the swingarm, pivot shaft, washer and pivot shaft nut.
NOTE:
Temporarily tighten the pivot shaft nut.
c. Turn the swingarm adjusting collar out to tighten it and so that it contacts the dust cover on the swingarm.
d. Tighten the pivot shaft nut.
e. Check the swingarm side play.
Refer to "REMOVING THE SWINGARM" on page 4-61.
4. Install:
5. Adjust:
Installing the thermostat
1. Install:
Thermostat
NOTE:
Install the thermostat with its breather hole "a"
facing up.
2. Install:
Copper washer
Coolant temperature sensor
CAUTION:Use extreme care when handling the
coolant
temperature sensor. Replace any part that
was dropped or subjected to ...
Troubleshooting charts
Starting problems or poor engine performance
Starting problems or poor engine performance
Engine overheating
WARNING
Do not remove the radiator cap when the engine and radiator are hot.
Scalding hot fluid and steam may be
blown out under pressure, which could cause serious injury. Be ...
Installing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Install:
Front fork leg
Temporarily tighten the upper and lower
bracket pinch bolts.
NOTE:
Make sure the inner tube end position "a" is 24.5
mm (0.96 in) from the top of the upper bracket.
2. Tighten:
Lower br ...