Yamaha YZF-R125 Service Manual: Installing the steering head
1. Lubricate:
- Upper bearing
- Lower bearing
- Bearing races
2. Install:
- Lower ring nut
- Rubber washer
- Upper ring nut
- Lock washer Refer to "CHECKING AND ADJUSTING THE STEERING HEAD" on page 3-22.
3. Install:
- Upper bracket
- Steering stem nut
NOTE:
Temporarily tighten the steering stem nut.
4. Install:
- Front fork legs Refer to "FRONT FORK" on page 4-44.
NOTE:
Temporarily tighten the upper and lower bracket pinch bolts.
5. Tighten:
- Steering stem nut
Checking the steering head
1. Wash:
Bearings
Bearing races
2. Check:
Bearings
Bearing races
Damage/pitting →Replace.
3. Replace:
Bearings
Bearing races
a. Remove the bearing races from the ste ...
Other materials:
Replacing an auxiliary light bulb
This model is equipped with two auxiliary
lights. If an auxiliary light bulb burns
out, replace it as follows.
Remove the socket (together with
the bulb) by pulling it out.
Auxiliary light bulb
Remove the burnt out bulb by pulling
it out.
Insert a new bulb into t ...
Checking the throttle body joint and air filter case joint
1. Remove:
Right lower side cowling
Left lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Throttle body joint "1"
Air filter case joint "2"
Cracks/damage Replace.
3. Install:
Right lower side cowling
Left lower side cowling
Refer to "GENERAL CHAS ...
Assembling the rear brake caliper
WARNING
Before installation, all internal brake components
should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake components
as they will cause the brake caliper
piston dust seal and piston seal to swell
and distort.
...