Yamaha YZF-R125 Service Manual: Installing the shift shaft
1. Install:
- Stopper lever "1"
- Stopper lever spring "2"
NOTE:
- Install the stopper lever spring as shown in the illustration.
- Hook the ends of the stopper lever spring onto the stopper lever and the crankcase boss "3".
- Mesh the stopper lever with the shift drum segment assembly.
2. Install:
- Shift shaft "1"
NOTE:
Hook the end of the shift shaft spring onto the shift shaft spring stopper "2".
Checking the shift shaft
1. Check:
Shift shaft
Bends/damage/wear Replace.
Shift shaft spring
Damage/wear Replace.
Checking the stopper lever
1. Check:
Stopper lever
Bends/damage Replace.
Roller ...
Balancer gear
...
Other materials:
Specifications
Dimensions:
Overall length:
2015 mm (79.3 in)
Overall width:
660 mm (26.0 in)
Overall height:
1065 mm (41.9 in)
Seat height:
818 mm (32.2 in)
Wheelbase:
1355 mm (53.3 in)
Ground clearance:
155 mm (6.10 in)
Minimum turning radius:
3100 mm (122.0 in)
Weight:
With oil and fuel:
138.0 k ...
Checking the rear brake hose
1. Check:
Brake hoses "1"
Cracks/damage/wear
Replace.
2. Check:
Brake hose holder "2"
Loose connection Tighten the
holder bolt.
Loose or open holder Fasten
properly.
3. Hold the vehicle upright and apply the rear
brake several times.
4. Check:
Brake ho ...
Assembling the rear brake caliper
WARNING
Before installation, all internal brake components
should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake components
as they will cause the brake caliper
piston dust seal and piston seal to swell
and distort.
...