Yamaha YZF-R125 Service Manual: Installing the relay arm
1. Lubricate:
- Spacers
- Bearings
- Oil seals
- Bolts (unthreaded shaft portion only)
2. Install:
- Bearing "1" (to the relay arm)
- Oil seal "2"
(to the relay arm)
3. Rear shock absorber assembly
4. Relay arm
5. Connecting arm
A. Left side
B. Right side
Checking the connecting arms and relay arm
1. Check:
Connecting arms
Relay arm
Damage/wear Replace.
2. Check:
Bearings
Oil seals
Damage/pitting Replace.
3. Check:
Spacers
Damage/scratches Replace.
...
Installing the rear shock absorber assembly
1. Install:
Rear shock absorber assembly
Relay arm "1"
NOTE:
Install the relay arm as shown in the illustration.
2. Tighten:
Rear shock absorber assembly upper nut
Relay arm nu ...
Other materials:
Removing the fuel tank
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Remove:
Fuel hose connector cover "1"
3. Disconnect:
Fuel hose "2"
CAUTION:
Be sure to disconnect the fuel hose by
hand. Do not forcefully disconnect the
hose with tools.
A ...
Installing the rear brake caliper
1. Install:
Brake caliper "1"
Copper washers
Brake hose "2"
Union bolt "3"
WARNINGProper brake hose routing is essential to
insure
safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-33.
CAUTION:When installing the brake hose onto the
brake calip ...
Engine oil and oil filter element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter element
replaced at the intervals specified
in the periodic maintenance and lubrication
chart.
To check the engine oil level
Place the vehicle on a level surface
and hol ...