Yamaha YZF-R125 Service Manual: Installing the rear wheel (disc)
1. Install:
- Rear brake disc
NOTE:
Tighten the brake disc bolts in stages and in a crisscross pattern.
2. Check:
- Rear brake disc Refer to "CHECKING THE REAR BRAKE DISC" on page 4-33.
3. Lubricate:
- Rear wheel axle
- Contact surface of rear wheel hub and rear wheel
- Wheel bearings
- Oil seal lips
4. Adjust:
- Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-21.
Adjusting the rear wheel static balance
NOTE:
After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
...
Front brake
...
Other materials:
Checking the rear brake disc
1. Remove:
Rear wheel
Refer to "REAR WHEEL" on page 4-12.
2. Check:
Brake disc
Damage/galling → Replace.
3. Measure:
Brake disc deflection
Out of specification → Correct the brake
disc
deflection or replace the brake disc.
Refer to "CHECKING THE FRONT BRAKE
DIS ...
Checking and lubricating the cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the cables
and cable ends should be lubricated
if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
WARNING! Damage to the out ...
Adjusting the rear disc brake
1. Check:
Brake pedal position
(distance "a" from the center of the rider footrest
to the center of the brake pedal)
Out of specification Adjust.
2. Adjust:
Brake pedal position
a. Loosen the locknut "1".
b. Remove the cotter pin "2", washer "3", and
pin "4".
c. Turn t ...