1. Install:
WARNING Proper brake hose routing is essential to insure safe vehicle operation. Refer to "CABLE ROUTING" on page 2-33. |
CAUTION: When installing the brake hose onto the brake master cylinder, make sure the brake pipe touches the projection "a" as shown. |
2. Fill:
WARNING
|
CAUTION: Brake fluid may damage painted surfaces and plastic parts. Therefore, always clean up any spilt brake fluid immediately. |
3. Bleed:
4. Check:
Refer to "CHECKING THE BRAKE FLUID LEVEL" on page 3-18.
5. Check:
Refer to "BLEEDING THE HYDRAULIC BRAKE SYSTEM" on page 3-20.
6. Adjust:
Assembling the crankcase
1. Thoroughly clean all the gasket mating surfaces
and crankcase mating surfaces.
2. Apply:
Sealant
(onto the crankcase mating surfaces)
NOTE:
Do not allow any sealant to come into contact
with the oil gallery.
3. Install:
Right crankcase
NOTE:
Turn the shift drum segment ...
Installing the crankshaft
1. Install:
Crankshaft "1"
NOTE:
Install the crankshaft with the crankshaft installer
pot "2", crankshaft installer bolt "3", adapter
(M12) "4" and spacer (crankshaft installer) "5".
CAUTION:To avoid scratching the crankshaft and to
ease the installation procedure, lubricate ...
Removing the fuel tank
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Remove:
Fuel hose connector cover "1"
3. Disconnect:
Fuel hose "2"
CAUTION:
Be sure to disconnect the fuel hose by
hand. Do not forcefully disconnect the
hose with tools.
A ...