Yamaha YZF-R125 Service Manual: Installing the radiator

1. Fill:

  • Cooling system (with the specified amount of the recommended coolant) Refer to "CHANGING THE COOLANT" on page 3-15.

2. Check:

  • Cooling system Leaks Repair or replace any
    faulty part.

3. Measure:

  • Radiator cap opening pressure Below the specified pressure Replace
    the radiator cap.

    Refer to "CHECKING THE RADIATOR" on page 6-3.

    Checking the radiator
    1. Check: Radiator fins obstruction clean. Apply compressed air to the rear of the radiator. Damage  repair or replace. NOTE: Straighten any flattened fins with a thin, flat-head scre ...

    Thermostat
    ...

    Other materials:

    Removing the starter clutch
    1. Remove: Starter clutch bolts "1" NOTE: While holding the generator rotor "2" with the sheave holder "3", remove the starter clutch bolts. Do not allow the sheave holder to touch the projection on the generator rotor. ...

    Coolant
    The coolant level should be checked before each ride. In addition, the coolant must be changed at the intervals specified in the periodic maintenance and lubrication chart. To check the coolant level Place the vehicle on a level surface and hold it in an upright position. TIP ...

    Checking the crankshaft
    1. Measure: Crankshaft runout Out of specification Replace the crankshaft, bearing or both. NOTE: Turn the crankshaft slowly. 2. Measure: Big end side clearance Out of specification Replace the crankshaft. 3. Measure: Crankshaft width Out of specification&nbs ...

    2026 Copyright www.yam-r125.net |