Yamaha YZF-R125 Service Manual: Installing the fuel hose
1. Install:
- Fuel hose
- Fuel hose connector cover
| CAUTION: When installing the fuel hose, make sure that it is securely connected, and that the fuel hose connector cover is in the correct position, otherwise the fuel hose will not be properly installed. |
NOTE:
- Wipe up any fuel remaining in the recess "a" in the fuel pump with a dry rag "1"
- After installing the fuel hose connector cover "2", make sure that it is installed securely.
Removing the fuel tank
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Remove:
Fuel hose connector cover "1"
3. Disconnect:
Fuel hose "2"
CAUTION:
Be sure ...
Checking the fuel pressure
1. Check:
Pressure regulator operation
a. Remove the fuel hose connector cover "1"
and disconnect the fuel hose "2" from the fuel
pump.
CAUTION:Although the fuel has been removed from ...
Other materials:
Installing the crankshaft
1. Install:
Crankshaft "1"
NOTE:
Install the crankshaft with the crankshaft installer
pot "2", crankshaft installer bolt "3", adapter
(M12) "4" and spacer (crankshaft installer) "5".
CAUTION:To avoid scratching the crankshaft and to
ease the installation procedure, lubricate ...
Coolant
The coolant level should be checked
before each ride. In addition, the coolant
must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
Place the vehicle on a level surface
and hold it in an upright position.
TIP
...
Checking the condition of the bulbs
The following procedure applies to all of the
bulbs.
1. Remove:
Bulb
WARNINGSince the headlight bulbs get extremely
hot,
keep flammable products and your hands
away from them until they have cooled
down.
CAUTION:
Be sure to hold the socket firmly when re ...