1. Install:
NOTE:
2. Check:
3. Lubricate:
4. Install:
NOTE:
Make sure the speed sensor and the wheel hub are installed with the two projections meshed into the two slots respectively.
5. Install:
NOTE:
Make sure the stopper "a" in the speed sensor fits over the slot "b" on the outer tube.
6. Tighten:
WARNING Make sure the brake hose is routed properly. |
CAUTION: Before tightening the wheel axle, push down hard on the handlebar(s) several times and check if the front fork rebounds smoothly. |
a. Insert the front wheel axle from the right side and tighten it from the left side to 59 Nm (5.9 m.kg, 43 ft.lb) without performing temporary tightening.
b. Tighten the front wheel axle pinch bolt to 14 Nm (1.4 m.kg, 10 ft.lb) without performing temporary tightening.
c. Check that the right end of the front wheel axle is flush with the front fork. If necessary, manually push the front wheel axle or lightly tap it with a soft hammer until its end is flush with the front fork. However, if the surface of the front wheel axle end is not parallel to the surface of the front fork, align a point on the outer edge of the axle with the fork, making sure that the axle does not protrude past the fork.
Checking the fuel pressure
1. Check:
Pressure regulator operation
a. Remove the fuel hose connector cover "1"
and disconnect the fuel hose "2" from the fuel
pump.
CAUTION:Although the fuel has been removed from
the fuel tank, be careful when removing the
fuel hose, since there may be fuel remaining
i ...
Genuine Yamaha Accessories
Choosing accessories for your vehicle
is an important decision. Genuine
Yamaha accessories, which are available
only from a Yamaha dealer, have
been designed, tested, and approved
by Yamaha for use on your vehicle.
Many companies with no connection to
Yamaha manufacture parts and access ...
Checking the front wheel
1. Check:
Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNINGDo not attempt to straighten a bent wheel
axle.
2. Check:
Tire
Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING TH ...