The following procedure applies to both of the front fork legs.
1. Install:
NOTE:
Make sure the inner tube end position "a" is 24.5 mm (0.96 in) from the top of the upper bracket.
2. Tighten:
WARNING Make sure the brake hose, clutch cable, and leads are routed properly. |
Checking the water pump
1. Check:
Water pump housing cover
Water pump housing
Cracks/damage Replace.
Impeller shaft
Cracks/damage/wear Replace.
Bearing
Rough movement Replace.
Radiator outlet hose
Cracks/damage Replace.
...
Throttle position sensor
1. Check:
Throttle position sensor
a. Connect the digital circuit tester to the terminals
of the throttle body sensor assembly
coupler as shown.
Positive tester probe →
gray/red terminal "1"
Negative tester probe →
gray/black terminal "2"
b. Measure the throttle pos ...
Installing the crankshaft
1. Install:
Crankshaft "1"
NOTE:
Install the crankshaft with the crankshaft installer
pot "2", crankshaft installer bolt "3", adapter
(M12) "4" and spacer (crankshaft installer) "5".
CAUTION:To avoid scratching the crankshaft and to
ease the installation procedure, lubricate ...