1. Install:
NOTE:
Pass the timing chain through the timing chain cavity.
2. Tighten:
NOTE:
3. Install:
a. Turn the crankshaft counterclockwise.
b. Align the "I" mark "a" on the generator rotor with the stationary pointer "b" on the generator cover.
c. Align the "I" mark "c" on the camshaft sprocket with the stationary pointer "d" on the cylinder head.
d. Install the timing chain onto the camshaft sprocket, and then install the camshaft sprocket onto the camshaft.
NOTE:
When installing the camshaft sprocket, be sure to keep the timing chain as tight as possible on the exhaust side.
CAUTION: Do not turn the crankshaft when installing the camshaft(s) to avoid damage or improper valve timing. |
e. While holding the camshaft, temporarily tighten the camshaft sprocket bolt.
f. Remove the wire from the timing chain.
4. Install:
a. Apply sealant to the timing chain tensioner bolt threads.
b. While lightly pressing the timing chain tensioner rod by hand, turn the tensioner rod fully clockwise with a thin screwdriver "1".
c. With the timing chain tensioner rod turned all the way into the timing chain tensioner housing (with the thin screwdriver still installed), install the gasket and the timing chain tensioner "2" onto the cylinder block.
d. Tighten the timing chain tensioner bolts "3" to the specified torque.
e. Remove the screwdriver, make sure the timing chain tensioner rod releases.
5. Turn:
6. Check:
Out of alignment Correct.
Refer to the installation steps above.
7. Tighten:
CAUTION: Be sure to tighten the camshaft sprocket bolt to the specified torque to avoid the possibility of the bolt coming loose and damaging the engine. |
8. Measure:
Valve clearance Out of specification Adjust.
Refer to "ADJUSTING THE VALVE CLEARANCE" on page 3-3.
Removing the rear brake caliper
NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
Union bolt "1"
Copper washers "2"
Brake hose "3"
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully. ...
Checking the coolant temperature sensor
1. Remove:
Coolant temperature sensor
WARNING
Handle the coolant temperature sensor
with special care.
Never subject the coolant temperature sensor
to strong shocks. If the coolant temperature
sensor is dropped, replace it.
2. Check:
Coolant temper ...
Checking the primary driven gear
1. Check:
Primary driven gear "1"
Damage/wear Replace the
primary drive
gear and clutch housing as a set.
Excessive noise during operation
Replace
the primary drive gear and clutch housing as
a set.
...