Yamaha YZF-R125 Service Manual: Installing the bearing retainer
1. Install:
- Bearing retainer "1"
NOTE:
- Install the bearing retainer "1" with its "OUT" mark "a" facing outward.
- Apply locking agent (LOCTITE) to the
threads of the bearing retainer bolt.
Checking the bearings and oil seal
1. Check:
Bearings
Clean and lubricate the bearings, and then
rotate the inner race with your finger.
Rough movement Replace.
Oil seal
Damage/wear Replace.
...
Assembling the crankcase
1. Thoroughly clean all the gasket mating surfaces
and crankcase mating surfaces.
2. Apply:
Sealant
(onto the crankcase mating surfaces)
NOTE:
Do not allow any sealant to come into conta ...
Other materials:
Installing the rear wheel (disc)
1. Install:
Rear brake disc
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-33.
3. Lubricate:
Rear wheel axle
Contact surface of rear wheel hub and rear
wheel
Whee ...
Disassembling the front wheel
1. Remove:
Oil seal
Wheel bearings
a. Clean the surface of the front wheel hub.
b. Remove the oil seal "1" with a flat-head
screwdriver.
NOTE:
To prevent damaging the wheel, place a rag "2"
between the screwdriver and the wheel surface.
c. Remove the wheel bearings "3" with a ge ...
Checking the oil pump
1. Check:
Oil pump drive gear
Oil pump driven gear
Oil pump housing
Oil pump housing cover
Cracks/damage/wear Replace the
defective
part(s).
2. Measure:
Inner-rotor-to-outer-rotor-tip clearance "a"
Outer-rotor-to-oil-pump-housing clearance
"b"
- Oil-pump-housing-to-inn ...