Yamaha YZF-R125 Owners Manual: Ignition circuit cut-off system
The ignition circuit cut-off system (comprising the sidestand switch, clutch switch and neutral switch) has the following functions.
- It prevents starting when the transmission is in gear and the sidestand is up, but the clutch lever is not pulled.
- It prevents starting when the transmission is in gear and the clutch lever is pulled, but the sidestand is still down.
- It cuts the running engine when the transmission is in gear and the sidestand is moved down.
Periodically check the operation of the ignition circuit cut-off system according to the following procedure.
WARNING
If a malfunction is noted, have a Yamaha
dealer check the system before riding.
Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
TIP
The built-in sidestand switch is part of
the ign ...
For your safety - pre-operation checks
Inspect your vehicle each time you use it to make sure the vehicle is in safe
operating condition. Always follow the inspection
and maintenance procedures and schedules described in the Owner's Ma ...
Other materials:
Disassembling the rear brake caliper
1. Remove:
Brake caliper piston "1"
Brake caliper piston dust seal "2"
Brake caliper piston seal "3"
a. Blow compressed air into the brake hose joint
opening "a" to force out the piston from the
brake caliper.
WARNING
Cover the brake caliper piston with a rag.
Be careful no ...
Adjusting the clutch lever free play
Adjusting the clutch lever free play
Clutch lever free play adjusting bolt
Clutch lever free play
The clutch lever free play should measure
10.0-15.0 mm (0.39-0.59 in) as
shown. Periodically check the clutch lever
free play and, if necessary, adjust it
as follows.
Slide the ...
Removing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Loosen:
Handlebar pinch bolt "1"
Handlebar bolt "2"
Upper bracket ...