Left
Left
1. Pass switch "PASS"
2. Dimmer switch "/"
3. Turn signal switch "/"
4. Horn switch""
Right
Right
Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch "/"
Set this switch to""
for the high
beam and to""
for the low beam.
Turn signal switch "
/"
To signal a right-hand turn, push this
switch to"".
To signal a left-hand
turn, push this switch to"".
When released,
the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has returned
to the center position.
Horn switch"
"
Press this switch to sound the horn.
Engine stop switch "/"
Set this switch to"
"
before starting
the engine. Set this switch to"
"
to
stop the engine in case of an emergency,
such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch"
"
Push this switch to crank the engine with the starter. See page 5-1 for starting instructions prior to starting the engine.
Checking the throttle body joint and air filter case joint
1. Remove:
Right lower side cowling
Left lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Throttle body joint "1"
Air filter case joint "2"
Cracks/damage Replace.
3. Install:
Right lower side cowling
Left lower side cowling
Refer to "GENERAL CHAS ...
Ecu self-diagnostic function
The ECU is equipped with a self-diagnostic function in order to ensure that
the fuel injection system is
operating normally. If this function detects a malfunction in the system, it
immediately operates the engine
under substitute characteristics and illuminates the engine trouble warning
li ...
Fi system
The fuel pump delivers fuel to the fuel injector via the fuel filter. The
pressure regulator maintains the
fuel pressure that is applied to the fuel injector at only 250 kPa (2.50 kg/cm²,
36.3 psi). Accordingly,
when the energizing signal from the ECU energizes the fuel injector, the fuel ...