This chart specifies tightening torques for standard fasteners with a standard ISO thread pitch.
Tightening torque specifications for special components or assemblies are provided for each chapter of this manual. To avoid warpage, tighten multi-fastener assemblies in a crisscross pattern and progressive stages until the specified tightening torque is reached. Unless otherwise specified, tightening torque specifications require clean, dry threads. Components should be at room temperature.
A. Distance between flats
B. Outside thread diameter
Checking the rectifier/regulator
1. Check:
Rectifier/regulator output voltage
Out of specification → Replace the
rectifier/
regulator.
a. Set the engine tachometer to the spark plug
lead.
b. Connect the pocket tester (DC 20 V) to the
rectifier/regulator coupler as shown.
Positive tester probe
red "1"
Negat ...
Air induction system
1. Air induction system hose (air filter case to
reed valve assembly)
2. Air induction system reed valve assembly
3. Air induction system hose (reed valve
assembly to exhaust pipe)
Checking the air induction system
Air injection
The air induction system burns unburned exhaust
gases b ...
Checking the clutch plates
The following procedure applies to all of the
clutch plates.
1. Check:
Clutch plate
Damage Replace the clutch
plates as a
set.
2. Measure:
Clutch plate warpage
(with a surface plate and thickness gauge "1")
Out of specification Replace
the clutch
plates as a set.
...