Yamaha YZF-R125 Service Manual: Gaskets, oil seals and o-rings
1. When overhauling the engine, replace all gaskets, seals and O-rings. All gasket surfaces, oil seal lips and O-rings must be cleaned.
2. During reassembly, properly oil all mating parts and bearings and lubricate the oil seal lips with grease.
- Oil
- Lip
- Spring
- Grease
Replacement parts
Use only genuine Yamaha parts for all replacements.
Use oil and grease recommended by
Yamaha for all lubrication jobs. Other brands
may be similar in function and appearance, but
inferior in qua ...
Lock washers/plates and cotter pins
After removal, replace all lock washers/plates
"1" and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock tabs
along a flat of the bolt or nut.
...
Other materials:
Intake air pressure sensor
1. Check:
Intake air pressure sensor output voltage
Out of specification Replace the throttle
body.
a. Connect the pocket tester (DC 20 V) to the
throttle body sensor assembly coupler as
shown.
Positive tester probe
pink/white "1"
Negative tester probe
gray/black "2"
...
Checking the rear shock absorber assembly
1. Check:
Rear shock absorber rod
Bends/damage Replace the rear
shock
absorber assembly.
Rear shock absorber
Oil leaks Replace the rear
shock absorber
assembly.
Spring
Damage/wear Replace the
rear shock absorber
assembly.
Bushing
Damage/wear Replace the rea ...
Cast wheels
To maximize the performance, durability,
and safe operation of your vehicle,
note the following points regarding the
specified wheels.
The wheel rims should be checked
for cracks, bends or warpage before
each ride. If any damage is
found, have a Yamaha dealer replace
the wheel. ...