Yamaha YZF-R125 Service Manual: Fuel system

Installing the water pump
1. Install: Water pump assembly "1" O-rings "2" NOTE: Align the projection "a" on the impeller shaft with the slit "b" on the camshaft sprocket bolt. Lubricate the O-rings with a thi ...

Fuel tank
...

Other materials:

Installing the generator
1. Install: Woodruff key Generator rotor Washer Generator rotor nut NOTE: Clean the tapered portion of the crankshaft and the generator rotor hub. When installing the generator rotor, make sure the woodruff key is properly sealed in the keyway of the crankshaft. 2. Tighte ...

Adjusting the engine idling speed
The engine idling speed must be checked and, if necessary, adjusted as follows at the intervals specified in the periodic maintenance and lubrication chart. The engine should be warm before making this adjustment. Remove panel A. Check the engine idling speed and, if necessary, ...

Checking the fuses
The following procedure applies to all of the fuses. CAUTION:To avoid a short circuit, always turn the main switch to "OFF" when checking or replacing a fuse. 1. Remove: Rider seat Refer to "GENERAL CHASSIS" on page 4-1. 2. Check: Fuse a. Connect the pocket te ...

2026 Copyright www.yam-r125.net |