To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
Front wheel axle pinch bolt
Speed sensor cable holder
Brake hose holder
Brake caliper bolt
Brake caliper
Axle bolt
Speedometer gear unit
To install the front wheel
TIP
Make sure that the projections on the
speed sensor rotor are aligned with the
notches in the wheel hub and that the
slot in the speed sensor fits over the retainer
on the fork leg.
TIP
Make sure that there is enough space
between the brake pads before installing
the brake caliper onto the brake
disc.
Tightening torques: Wheel axle: 59 Nm (5.9 m.kgf, 43 ft.lbf) Front wheel axle pinch bolt: 14 Nm (1.4 m.kgf, 10 ft.lbf) Brake caliper bolt: 30 Nm (3.0 m.kgf, 22 ft.lbf) |
Lubrication diagrams
Clutch push lever
Main axle
Drive axle
Crankshaft
Oil filter
Oil pump assembly
Oil strainer
To cylinder head
Camshaft
Crankshaft
Main axle
Drive axle
...
Drive chain slack
The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
Place the motorcycle on the sidestand.
TIP
When checking and adjusting the drive
chain slack, there should be no weight
on the motorcycle.
Shift the transmission in ...
Removing the valves
The following procedure applies to all of the
valves and related components.
NOTE:
Before removing the internal parts of the cylinder
head (e.g., valves, valve springs, valve seats),
make sure the valves properly seal.
1. Check:
Valve sealing
Leakage at the valve seat Check
the valve
...