Yamaha YZF-R125 Service Manual: Electrical system
- Ignition system
- Electric starting system
- Charging system
- Lighting system
- Signaling system
- Cooling system
- Fuel injection system
- Circuit diagram
- Ecu self-diagnostic function
- Self-diagnostic function table
- Troubleshooting method
- Diagnostic mode
- Troubleshooting details
- Fuel pump system
- Electrical components
- Checking the switches
- Checking the bulbs and bulb sockets
- Checking the fuses
- Checking and charging the battery
- Checking the relays
- Checking the turn signal relay
- Checking the diode
- Checking the spark plug cap
- Checking the ignition coil
- Checking the ignition spark gap
- Checking the crankshaft position sensor
- Checking the lean angle sensor
- Checking the starter motor operation
- Checking the stator coil
- Checking the rectifier/regulator
- Checking the horn
- Checking the fuel sender
- Checking the speed sensor
- Checking the radiator fan motor
- Checking the coolant temperature sensor
- Checking the throttle body sensor assembly
- Checking the fid (fast idle solenoid)
Air induction system
1. Air induction system hose (air filter case to
reed valve assembly)
2. Air induction system reed valve assembly
3. Air induction system hose (reed valve
assembly to exhaust pipe)
Checki ...
Ignition system
...
Other materials:
Checking the clutch springs
The following procedure applies to all of the
clutch springs.
1. Check:
Clutch spring
Damage Replace the clutch
springs as a
set.
2. Measure:
Clutch spring free length "a"
Out of specification Replace
the clutch
springs as a set.
...
Changing the engine oil
1. Remove:
Right bottom cowling
Right upper side cowling
Right lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Place a container under the engine oil drain
bolt.
4. Install:
Engine oil d ...
Checking and lubricating the brake and shift pedals
Brake pedal
Brake pedal
Shift pedal
Shift pedal
The operation of the brake and shift
pedals should be checked before each
ride, and the pedal pivots should be lubricated
if necessary.
Recommended lubricant:Lithium-soap-based grease
...