Yamaha YZF-R125 Service Manual: Electric starting system
Troubleshooting
The ignition system fails to operate (no spark or intermittent spark).
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Right side cover
4. Left side pan ...
Circuit diagram
4. Main fuse
5. Main switch
7. Clutch switch
8. Sidestand switch
9. Battery
10.Starter relay
11.Starter motor
12.Starting circuit cut-off relay
13.Diode
14.Neutral switch
16.Start switch ...
Other materials:
Removing the lower bracket
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Remove:
Upper ring nut
Rubber washer
Lower ring nut "1"
Lower bracket
NOTE:
Remove the lower ring nut with the steering nut
wrench "2".
...
Checking the stator coil
1. Disconnect:
Stator coil coupler
(from the wire harness)
2. Check:
Stator coil resistance
Out of specification → Replace the
crankshaft
position sensor/stator assembly.
a. Connect the pocket tester ( ×
1) to the stator
coil coupler as shown.
b. Measure the sta ...
Checking and lubricating the brake and clutch levers
Brake lever
Brake lever
Clutch lever
Clutch lever
The operation of the brake and clutch
levers should be checked before each
ride, and the lever pivots should be lubricated
if necessary.
Recommended lubricants:Brake lever:
Silicone grease
Clutch lever:
Lithium-soap ...