The drive chain slack should be checked before each ride and adjusted if necessary.
To check the drive chain slack
TIP
When checking and adjusting the drive
chain slack, there should be no weight
on the motorcycle.
Drive chain slack: 30.0-40.0 mm (1.18-1.57 in) |
Drive chain slack
To adjust the drive chain slack
Axle nut
Drive chain slack adjusting bolt
Locknut
Alignment marks
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
Tightening torques: Axle nut: 85 Nm (8.5 m.kgf, 61 ft.lbf) Locknut: 16 Nm (1.6 m.kgf, 11 ft.lbf) |
Removing the rear brake master cylinder
NOTE:
Before removing the rear brake master cylinder,
drain the brake fluid from the entire brake system.
1. Disconnect:
Rear brake light switch coupler
2. Loosen:
Rear brake light switch "1"
3. Remove:
Rear brake master cylinder bolts
Rear brake master cylinder
4. Remove:
...
Assembling the front brake caliper
WARNING
Before installation, all internal brake components
should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake components
as they will cause the brake caliper
dust seals and piston seals to swell and
distort.
...
Bleeding the hydraulic brake system
WARNINGBleed the hydraulic brake system whenever:
the system is disassembled.
a brake hose is loosened, disconnected or
replaced.
the brake fluid level is very low.
brake operation is faulty.
NOTE:
Be careful not to spill any brake fluid or allow
th ...