1. Remove:
a. Clean the surface of the front wheel hub.
b. Remove the oil seal "1" with a flat-head screwdriver.
NOTE:
To prevent damaging the wheel, place a rag "2" between the screwdriver and the wheel surface.
c. Remove the wheel bearings "3" with a general bearing puller.
Replacing the headlight bulbs
The following procedure applies to the low beam
headlight bulb.
1. Remove:
Headlight bulb cover "1"
2. Remove:
Headlight bulb holder "1"
3. Remove:
Headlight bulb "1"
WARNINGSince the headlight bulb gets extremely
hot,
keep flammable products and your ...
Checking the starter clutch
1. Check:
Starter clutch rollers "1"
Starter clutch spring caps "2"
Starter clutch springs "3"
Damage/wear Replace the starter
clutch
assembly.
2. Check:
Starter clutch idle gear
Starter clutch gear
Burrs/chips/roughness/wear Replace the
defective part(s).
3. Check:
...
Parking
When parking, stop the engine, and
then remove the key from the main
switch.
WARNING
Since the engine and exhaust
system can become very hot,
park in a place where pedestrians
or children are not likely to
touch them and be burned.
Do not park on a slope or on soft
ground, ...