Yamaha YZF-R125 Service Manual: Disassembling the front fork legs

Yamaha YZF-R125 Service Manual / Chassis / Front fork / Disassembling the front fork legs

The following procedure applies to both of the front fork legs.

1. Remove:

  • Rubber cap
  • Clip "1"
  • Front fork cap "2" (with O-ring)
  • Fork spring

NOTE:

Push the front fork cap in the direction of the arrow shown in the illustration to remove the clip.

Disassembling the front fork legs


2. Drain:

  • Fork oil

NOTE:

Stroke the inner tube several times while draining the fork oil.

Disassembling the front fork legs


3. Remove:

  • Dust seal "1"
  • Oil seal clip "2" (with a flat-head screwdriver)

CAUTION:

Do not scratch the inner tube.

4. Remove:

  • Damper rod bolt "1"
  • Damper rod

NOTE:

While holding the damper rod with the damper rod holder "2" and T-handle "3", loosen the damper rod bolt.


Disassembling the front fork legs


    Removing the front fork legs
    The following procedure applies to both of the front fork legs. 1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of ...

    Checking the front fork legs
    The following procedure applies to both of the front fork legs. 1. Check: Inner tube Outer tube Bends/damage/scratches Replace. WARNINGDo not attempt to straighten a bent inner ...

    Other materials:

    Removing the fuel tank
    1. Extract the fuel in the fuel tank through the fuel tank filler hole with a pump. 2. Remove: Fuel hose connector cover "1" 3. Disconnect: Fuel hose "2" CAUTION: Be sure to disconnect the fuel hose by hand. Do not forcefully disconnect the hose with tools. A ...

    Lubricating the drive chain
    The drive chain consists of many interacting parts. If the drive chain is not maintained properly, it will wear out quickly. Therefore, the drive chain should be serviced, especially when the vehicle is used in dusty areas. This vehicle has a drive chain with small rubber O-rings between eac ...

    Removing the rear brake master cylinder
    NOTE: Before removing the rear brake master cylinder, drain the brake fluid from the entire brake system. 1. Disconnect: Rear brake light switch coupler 2. Loosen: Rear brake light switch "1" 3. Remove: Rear brake master cylinder bolts Rear brake master cylinder 4. Remove: ...

    2024 Copyright www.yam-r125.net |