It is possible to monitor the sensor output data or check the activation of actuators with the FI diagnostic tool connected to the vehicle and set to the normal mode or the diagnostic monitoring mode.
Changing the coolant
1. Remove:
Lower side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Radiator cap "1"
WARNINGA hot radiator is under pressure.
Therefore,
do not remove the radiator cap when the engine
is hot. Scalding hot fluid and steam may
be blown out, which c ...
Checking the shift drum assembly
1. Check:
Shift drum groove
Damage/scratches/wear Replace
the shift
drum assembly.
Shift drum segment "1"
Damage/wear Replace the
shift drum assembly.
Shift drum bearing "2"
Damage/pitting Replace the
shift drum assembly.
...
Special tools
The following special tools are necessary for complete and accurate tune-up
and assembly. Use only
the appropriate special tools as this will help prevent damage caused by the use
of inappropriate tools
or improvised techniques. Special tools, part numbers or both may differ
depending on the ...