Yamaha YZF-R125 Service Manual: Cylinder and piston
- Removing the piston
- Checking the cylinder and piston
- Checking the piston rings
- Checking the piston pin
- Installing the piston and cylinder
Installing the valves
The following procedure applies to all of the
valves and related components.
1. Deburr:
Valve stem end
(with an oil stone)
2. Lubricate:
Valve stem "1"
Valve stem seal "2"
(with ...
Removing the piston
1. Remove:
Piston pin clips "1"
Piston pin "2"
Piston "3"
CAUTION:Do not use a hammer to drive the piston
pin
out.
NOTE:
Before removing the piston pin c ...
Other materials:
Removing the fuel tank
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Remove:
Fuel hose connector cover "1"
3. Disconnect:
Fuel hose "2"
CAUTION:
Be sure to disconnect the fuel hose by
hand. Do not forcefully disconnect the
hose with tools.
A ...
Installing the rear brake master cylinder
1. Install:
Copper washers "1"
Brake hose "2"
Rear brake light switch "3"
WARNINGProper brake hose routing is essential to
insure
safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-33.
CAUTION:When installing the brake hose onto the
brake master ...
Bleeding the hydraulic brake system
WARNINGBleed the hydraulic brake system whenever:
the system is disassembled.
a brake hose is loosened, disconnected or
replaced.
the brake fluid level is very low.
brake operation is faulty.
NOTE:
Be careful not to spill any brake fluid or allow
th ...