NOTE:
There is a check hose "1" at the bottom of the air filter case. If dust and/or water collects in this hose, clean the air filter element and air filter case.
1. Remove:
2. Remove:
3. Remove:
4. Clean:
5. Check:
6. Install:
CAUTION: Never operate the engine without the air filter element installed. Unfiltered air will cause rapid wear of engine parts and may damage the engine. Operating the engine without the air filter element will also affect throttle body tuning, leading to poor engine performance and possible overheating. |
NOTE:
Make sure the air filter element is properly installed in the air filter case.
7. Install:
Intake air pressure sensor
1. Check:
Intake air pressure sensor output voltage
Out of specification Replace the throttle
body.
a. Connect the pocket tester (DC 20 V) to the
throttle body sensor assembly coupler as
shown.
Positive tester probe
pink/white "1"
Negative tester probe
gray/black "2"
...
Ignition circuit cut-off system
The ignition circuit cut-off system (comprising
the sidestand switch, clutch
switch and neutral switch) has the following
functions.
It prevents starting when the transmission
is in gear and the sidestand
is up, but the clutch lever is
not pulled.
It prevents starting when the t ...
Troubleshooting charts
Starting problems or poor engine performance
Starting problems or poor engine performance
Engine overheating
WARNING
Do not remove the radiator cap when the engine and radiator are hot.
Scalding hot fluid and steam may be
blown out under pressure, which could cause serious injury. Be ...