Yamaha YZF-R125 Service Manual: Circuit diagram
4. Main fuse
5. Main switch
9. Battery
25.ECU (engine control unit)
36.License plate light
37.Tail/brake light
44.Headlight relay
46.Pass switch
47.Dimmer switch
51.Headlight (low beam)
52.Auxiliary light
54.Headlight (high beam)
58.Meter light
60.High beam indicator light
64.Ignition fuse
65.Headlight fuse
66.Signaling system fuse
Lighting system
...
Troubleshooting
Any of the following fail to light: headlight, high beam indicator light,
taillight, license plate light, auxiliary
light or meter light.
NOTE:
Before troubleshooting, remove the following par ...
Other materials:
Rear wheel
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
Loosen the axle nut.
Axle nut
Drive chain slack adjusting bolt
Locknut
Brake caliper
Lift the rear wheel off the ground
according to the pr ...
Checking the relays
Check each switch for continuity with the pocket
tester. If the continuity reading is incorrect, replace
the relay.
1. Disconnect the relay from the wire harness.
2. Connect the pocket tester ( × 1) and battery
(12 V) to the relay terminal as shown.
Check the relay operation.
Out ...
Checking the clutch plates
The following procedure applies to all of the
clutch plates.
1. Check:
Clutch plate
Damage Replace the clutch
plates as a
set.
2. Measure:
Clutch plate warpage
(with a surface plate and thickness gauge "1")
Out of specification Replace
the clutch
plates as a set.
...