The following procedure applies to both of the wheels.
1. Check:
Wheel Damage/out-of-round → Replace.
WARNING Never attempt to make any repairs to the wheel. |
NOTE:
After a tire or wheel has been changed or replaced, always balance the wheel.
Installing the relay arm
1. Lubricate:
Spacers
Bearings
Oil seals
Bolts (unthreaded shaft portion only)
2. Install:
Bearing "1"
(to the relay arm)
Oil seal "2"
(to the relay arm)
3. Rear shock absorber assembly
4. Relay arm
5. Connecting arm
A. Left side
B. Right side ...
Checking the horn
1. Check:
Horn resistance
Out of specification Replace.
a. Disconnect the horn connectors from the
horn terminals.
b. Connect the pocket tester ( × 1) to the horn
terminals.
Positive tester probe
horn terminal "1"
Negative tester probe
horn terminal "2"
c. Measure t ...
Installing the cylinder head
1. Install:
Cylinder head
NOTE:
Pass the timing chain through the timing chain
cavity.
2. Tighten:
Cylinder head bolts "1"
Cylinder head bolts "2"
NOTE:
Lubricate the cylinder head bolts and washers
with engine oil.
Tighten the cylinder head bolts in the proper
tighten ...