The following procedure applies to all of the valves and valve seats.
1. Eliminate:
2. Check:
3. Measure:
a. Apply Mechanic's blueing dye (Dykem) "b" onto the valve face.
b. Install the valve into the cylinder head.
c. Press the valve through the valve guide and onto the valve seat to make a clear impression.
d. Measure the valve seat width.
NOTE:
Where the valve seat and valve face contacted one another, the blueing will have been removed.
4. Lap:
NOTE:
After replacing the cylinder head or replacing the valve and valve guide, the valve seat and valve face should be lapped.
a. Apply a coarse lapping compound "a" to the valve face.
CAUTION: Do not let the lapping compound enter the gap between the valve stem and the valve guide. |
b. Apply molybdenum disulfide oil onto the valve stem.
c. Install the valve into the cylinder head.
d. Turn the valve until the valve face and valve seat are evenly polished, then clean off all of the lapping compound.
NOTE:
For the best lapping results, lightly tap the valve seat while rotating the valve back and forth between your hands.
e. Apply a fine lapping compound to the valve face and repeat the above steps.
f. After every lapping procedure, be sure to clean off all of the lapping compound from the valve face and valve seat.
g. Apply Mechanic's blueing dye (Dykem) "b" onto the valve face.
h. Install the valve into the cylinder head.
i. Press the valve through the valve guide and onto the valve seat to make a clear impression.
j. Measure the valve seat width "c" again. If the valve seat width is out of specification, reface and lap the valve seat.
Troubleshooting
Any of the following fail to light: headlight, high beam indicator light,
taillight, license plate light, auxiliary
light or meter light.
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
...
Checking the coolant temperature sensor
1. Remove:
Coolant temperature sensor
WARNING
Handle the coolant temperature sensor
with special care.
Never subject the coolant temperature sensor
to strong shocks. If the coolant temperature
sensor is dropped, replace it.
2. Check:
Coolant temper ...
Specifications
Dimensions:
Overall length:
2015 mm (79.3 in)
Overall width:
660 mm (26.0 in)
Overall height:
1065 mm (41.9 in)
Seat height:
818 mm (32.2 in)
Wheelbase:
1355 mm (53.3 in)
Ground clearance:
155 mm (6.10 in)
Minimum turning radius:
3100 mm (122.0 in)
Weight:
With oil and fuel:
138.0 k ...