1. Check:
Turn signal relay input voltage Out of specification →The wiring circuit from the main switch to the turn signal relay coupler is faulty and must be repaired.
a. Connect the pocket tester (DC 20 V) to the turn signal relay terminal as shown.
- Positive tester probe
brown "1"
- Negative tester probe
ground
b. Set the main switch to "ON".
c. Measure the turn signal relay input voltage.
2. Check:
Turn signal relay output voltage Out of specification Replace.
a. Connect the pocket tester (DC 20 V) to the turn signal relay terminal as shown.
Positive tester probe
brown/white "1"
Negative tester probe
ground
b. Set the main switch to "ON".
c. Measure the turn signal relay output voltage.
Removing and installing the cowlings and panel
Removing and installing the cowlings and panel
Cowling A
Cowling B
Cowling C
Cowling D
Panel A
The cowlings and panel shown need to
be removed to perform some of the
maintenance jobs described in this
chapter. Refer to this section each time
a cowling or panel needs to be ...
Removing the front brake caliper
NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
Brake hose union bolt "1"
Copper washers "2"
Brake hose "3"
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
...
Removing the throttle body
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Disconnect:
Fuel hose
WARNINGCover the fuel hose connections with a
cloth
when disconnecting them. Residual pressure
in the fuel lines could cause fuel to
spurt out when removing the h ...