Yamaha YZF-R125 Service Manual: Checking the steering head
1. Wash:
- Bearings
- Bearing races
2. Check:
- Bearings
- Bearing races Damage/pitting →Replace.
3. Replace:
- Bearings
- Bearing races
a. Remove the bearing races from the steering head pipe with a long rod "1" and hammer.
b. Remove the bearing race from the lower bracket with a floor chisel "2" and hammer.
c. Install a new dust seal and new bearing races.
| CAUTION: If the bearing races are not installed properly, the steering head pipe could be damaged. |
NOTE:
- Always replace the bearings and bearing races as a set.
- Whenever the steering head is disassembled, replace the dust seal.
4. Check:
- Upper bracket
- Lower bracket (along with the steering stem) Bends/cracks/damage →Replace.
Removing the lower bracket
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Remove:
Upper ring nut
Rubber washer
Lower r ...
Installing the steering head
1. Lubricate:
Upper bearing
Lower bearing
Bearing races
2. Install:
Lower ring nut
Rubber washer
Upper ring nut
Lock washer
Refer to "CHECKING AND ADJUSTING
THE STEERING HEAD ...
Other materials:
Checking the front fork
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Check:
Inner tube
Damage/scratches Replace.
Oil seal
Oil leakage Replace.
3. Hold the vehicle upright and apply the front
brake.
4. Che ...
Cast wheels
To maximize the performance, durability,
and safe operation of your vehicle,
note the following points regarding the
specified wheels.
The wheel rims should be checked
for cracks, bends or warpage before
each ride. If any damage is
found, have a Yamaha dealer replace
the wheel. ...
Installing the front brake caliper
1. Install:
Brake caliper "1"
(temporarily)
Copper washers "2"
Brake hose "3"
Brake hose union bolt "4"
WARNINGProper brake hose routing is essential to
insure
safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-33.
CAUTION:
Install the brake ...