1. Check:
2. Measure:
3. Measure:
NOTE:
The mica of the commutator must be undercut to ensure proper operation of the commutator.
4. Measure:
a. Measure the armature assembly resistances with the pocket tester.
b. If any resistance is out of specification, replace the starter motor.
5. Measure:
6. Measure:
7. Check:
Gear teeth Damage/wear Replace the gear.
8. Check:
Removing the swingarm
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle
so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Measure:
Swingarm side play
Swingarm vertical movement
a. Me ...
Changing the engine oil
1. Remove:
Right bottom cowling
Right upper side cowling
Right lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Place a container under the engine oil drain
bolt.
4. Install:
Engine oil d ...
Removing the rear brake caliper
NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
Union bolt "1"
Copper washers "2"
Brake hose "3"
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully. ...