1. Check:
Speed sensor output voltage Out of specification → Replace.
a. Connect the pocket tester (DC 20 V) to the speed sensor coupler (wire harness end) as shown.
b. Set the main switch to "ON".
c. Elevate the front wheel and slowly rotate it.
d. Measure the voltage of gray and gray/black.
With each full rotation of the front wheel, the voltage reading should cycle from 0 V to 5.0 V to 0 V to 5.0 V.
Assembling the front wheel
1. Install:
Wheel bearings
Oil seal
a. Install the new wheel bearings and oil seal in
the reverse order of disassembly.
CAUTION:Do not contact the wheel bearing inner
race
"1" or balls "2". Contact should be made
only with the outer race "3".
NOTE:
Use a socket " ...
Air induction system
1. Air induction system hose (air filter case to
reed valve assembly)
2. Air induction system reed valve assembly
3. Air induction system hose (reed valve
assembly to exhaust pipe)
Checking the air induction system
Air injection
The air induction system burns unburned exhaust
gases b ...
Checking the relays
Check each switch for continuity with the pocket
tester. If the continuity reading is incorrect, replace
the relay.
1. Disconnect the relay from the wire harness.
2. Connect the pocket tester ( × 1) and battery
(12 V) to the relay terminal as shown.
Check the relay operation.
Out ...