Yamaha YZF-R125 Service Manual: Checking the spark plug
1. Remove:
- Right side cover Refer to "GENERAL CHASSIS" on page 4-1.
2. Disconnect:
- Spark plug cap
3. Remove:
- Spark plug
| CAUTION: Before removing the spark plug, blow away any dirt accumulated in the spark plug well with compressed air to prevent it from falling into the cylinder. |
4. Check:
Spark plug type
Incorrect →Change.
5. Check:
- Electrode "1" Damage/wear→ Replace the spark plug.
- Insulator "2"
Abnormal color→ Replace the spark plug.
Normal color is medium-to-light tan.
6. Clean:
- Spark plug (with a spark plug cleaner or wire brush)
7. Measure:
- Spark plug gap "a"
(with a wire thickness gauge)
Out of specification → Regap.
8. Install:
- Spark plug
NOTE:
Before installing the spark plug, clean the spark plug and gasket surface.
9. Connect:
- Spark plug cap
10.Install:
- Right side cover Refer to "GENERAL CHASSIS" on page 4-1.
Adjusting the throttle cable free play
NOTE:
Prior to adjusting the throttle cable free play, the
engine idling speed should be adjusted.
1. Check:
Throttle cable free play "a"
Out of specification →Adjust.
2. Remov ...
Checking the ignition timing
NOTE:
Prior to checking the ignition timing, check the
wiring connections of the entire ignition system.
Make sure all connections are tight and free of
corrosion.
1. Remove:
Rider seat
L ...
Other materials:
Checking the radiator
1. Check:
Radiator fins
obstruction clean.
Apply compressed air to the rear of the radiator.
Damage repair or replace.
NOTE:
Straighten any flattened fins with a thin, flat-head
screwdriver.
2. Check:
Radiator hoses
Cracks/damage Replace.
3. Measure:
Radiator cap ...
Identification
Vehicle identification number
The vehicle identification number "1" is stamped
into the right side of the steering head pipe.
Model label
The model label "1" is affixed to the frame. This
information will be needed to order spare parts.
...
Troubleshooting
Any of the following fail to light: headlight, high beam indicator light,
taillight, license plate light, auxiliary
light or meter light.
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
...