The following procedure applies to all of the rocker arms and rocker arm shafts.
1. Check:
2. Check:
3. Measure:
4. Measure:
5. Calculate:
NOTE:
Calculate the clearance by subtracting the rocker arm shaft outside diameter from the rocker arm inside diameter.
Out of specification Replace the
defective
part(s).
Introduction
WARNINGDisc brake components rarely require
disassembly.
Therefore, always follow these preventive
measures:
Never disassemble brake components unless
absolutely necessary.
If any connection on the hydraulic brake
system is disconnected, the entire brake
sy ...
Checking the front wheel
1. Check:
Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNINGDo not attempt to straighten a bent wheel
axle.
2. Check:
Tire
Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING TH ...
Checking the clutch springs
The following procedure applies to all of the
clutch springs.
1. Check:
Clutch spring
Damage Replace the clutch
springs as a
set.
2. Measure:
Clutch spring free length "a"
Out of specification Replace
the clutch
springs as a set.
...