Check each switch for continuity with the pocket tester. If the continuity reading is incorrect, replace the relay.
1. Disconnect the relay from the wire harness.
2. Connect the pocket tester ( × 1) and battery (12 V) to the relay terminal as shown.
Check the relay operation.
Out of specification → Replace.
Starter relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Starting circuit cut-off relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Headlight relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Radiator fan motor relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Checking the swingarm
1. Check:
Swingarm
Bends/cracks/damage
Replace.
2. Check:
Pivot shaft
Roll the pivot shaft on a flat surface.
Bends Replace.
WARNINGDo not attempt to straighten a bent pivot
shaft.
3. Wash:
Pivot shaft
Washer
Swingarm adjusting collar
Du ...
Checking the front wheel
1. Check:
Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNINGDo not attempt to straighten a bent wheel
axle.
2. Check:
Tire
Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING TH ...
Front wheel
To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
Front wheel axle pinch bolt
Lift the front wheel of ...