Yamaha YZF-R125 Service Manual: Checking the rear brake hose
1. Check:
- Brake hoses "1"
Cracks/damage/wear
Replace.
2. Check:
- Brake hose holder "2"
Loose connection
Tighten the
holder bolt.Loose or open holder
Fasten
properly.
3. Hold the vehicle upright and apply the rear brake several times.
4. Check:
Brake hoses
Brake fluid leakage Replace the
damaged
hose.
Refer to "REAR BRAKE" on page 4-28.
Checking the front brake hose
1. Check:
Brake hose "1"
Cracks/damage/wear
Replace.
2. Check:
Brake hose holder "2"
Loose connection Tighten the
holder bolt.
3. Hold the vehicle upright and apply ...
Bleeding the hydraulic brake system
WARNINGBleed the hydraulic brake system whenever:
the system is disassembled.
a brake hose is loosened, disconnected or
replaced.
the brake fluid level is very low.
brak ...
Other materials:
Checking the condition of the bulbs
The following procedure applies to all of the
bulbs.
1. Remove:
Bulb
WARNINGSince the headlight bulbs get extremely
hot,
keep flammable products and your hands
away from them until they have cooled
down.
CAUTION:
Be sure to hold the socket firmly when re ...
Installing the camshaft and rocker arms
1. Lubricate:
Rocker arms
Rocker arm shafts
2. Lubricate:
Camshaft
3. Install:
Camshaft "1"
NOTE:
Make sure that the camshaft projections "a" and
hole "b" are positioned as shown in the illustration.
4. Install:
Rocker arms
Rocker arm shafts "1"
NOTE:
Make ...
Removing the piston
1. Remove:
Piston pin clips "1"
Piston pin "2"
Piston "3"
CAUTION:Do not use a hammer to drive the piston
pin
out.
NOTE:
Before removing the piston pin clip, cover the
crankcase opening with a clean rag to prevent
the piston pin clip from falling in ...