Yamaha YZF-R125 Service Manual: Checking the rear brake caliper
1. Check:
- Brake caliper piston "1"
Rust/scratches/wear
Replace the
brake caliper piston. - Brake caliper cylinder "2"
Scratches/wear
Replace the
brake caliper assembly. - Brake caliper body "3"
Cracks/damage
Replace the
brake caliper assembly. - Brake fluid delivery passages
(brake caliper body)Obstruction
Blow out with compressed air.Obstruction Blow out with compressed air.
| WARNING Whenever a brake caliper is disassembled, replace the brake caliper piston dust seals and piston seals. |
2. Check:
- Brake caliper bracket
Cracks/damage
Replace.
Disassembling the rear brake caliper
1. Remove:
Brake caliper piston "1"
Brake caliper piston dust seal "2"
Brake caliper piston seal "3"
a. Blow compressed air into the brake hose joint
opening "a" to force out the pisto ...
Assembling the rear brake caliper
WARNING
Before installation, all internal brake components
should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake components
as ...
Other materials:
Cleaning the air filter element
NOTE:
There is a check hose "1" at the bottom of the air
filter case. If dust and/or water collects in this
hose, clean the air filter element and air filter
case.
1. Remove:
Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Fuel tank
Refer to "FUEL TANK" on page ...
Changing the coolant
1. Remove:
Lower side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Radiator cap "1"
WARNINGA hot radiator is under pressure.
Therefore,
do not remove the radiator cap when the engine
is hot. Scalding hot fluid and steam may
be blown out, which c ...
Disassembling the water pump
1. Remove:
Water pump seal "1"
NOTE:
Remove the water pump seal from the inside of
the water pump housing "2".
2. Remove:
Bearing "1"
NOTE:
Remove the bearing from the outside of the water
pump housing "2".
...