1. Check:
2. Measure:
Out of specification Replace
the oil pump.
1. Inner rotor
2. Outer rotor
3. Oil pump housing
3. Check:
Oil pump operation
Rough movement Repeat steps (1)
and
(2) or replace the defective part(s).
Ignition circuit cut-off system
The ignition circuit cut-off system (comprising
the sidestand switch, clutch
switch and neutral switch) has the following
functions.
It prevents starting when the transmission
is in gear and the sidestand
is up, but the clutch lever is
not pulled.
It prevents starting when the t ...
Replacing the front brake pads
NOTE:
When replacing the brake pads, it is not necessary
to disconnect the brake hose or disassemble
the brake caliper.
1. Measure:
Brake pad wear limit "a"
Out of specification Replace
the brake
pads as a set.
2. Install:
Brake pad support
Brake pad spring
Brake pads ...
Removing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Loosen:
Handlebar pinch bolt "1"
Handlebar bolt "2"
Upper bracket ...