1. Remove:
2. Check:
Lean angle sensor output voltage Out of specification Replace.
a. Connect the lean angle sensor to the wire harness.
b. Connect the pocket tester (DC 20 V) to the lean angle sensor coupler as shown.
Positive tester probe
yellow/green "1"
Negative tester probe
gray/black "2"
c. Set the main switch to "ON".
d. Tilt the lean angle sensor to 65.
e. Measure the lean angle sensor output voltage.
Special tools
The following special tools are necessary for complete and accurate tune-up
and assembly. Use only
the appropriate special tools as this will help prevent damage caused by the use
of inappropriate tools
or improvised techniques. Special tools, part numbers or both may differ
depending on the ...
Incorrect engine idling speed
Engine
1. Cylinder and cylinder head
Incorrect valve clearance
Damaged valve train components
2. Air filter
Clogged air filter element
Fuel system
1. Throttle body
Damaged or loose throttle body joint
Improperly adjusted engine idling speed (idle
adjusting screw)
Improper ...
Checking the rear brake caliper
1. Check:
Brake caliper piston "1"
Rust/scratches/wear Replace the
brake
caliper piston.
Brake caliper cylinder "2"
Scratches/wear Replace the
brake caliper
assembly.
Brake caliper body "3"
Cracks/damage Replace the
brake caliper
assembly.
Brake fluid deli ...